Advertisement
Step 6: Join Swing and Slide Wall Assemblies
Part 1
A: With at least two helpers lift the Slide Wall Assembly and Swing Wall Assembly so the (041) Narrow Back
Panel and (042) Narrow Front Panel meet with (052) Back Wall Panel and (051) Front Wall Panel and are tight
together as shown in fig. 6.1.
B: Make sure the assembly is square then on the inside of the assembly, tight to (040) Slide End Panel and flush
to the bottom of the panels attach 1 (060) Floor Joist to (041) Narrow Back Panel and (052) Back Wall Panel
and a second (060) Floor Joist to (042) Narrow Front Panel and (051) Front Wall Panel with 4 (S7) #12 x 2" Pan
Screws per board. (fig. 6.1 and 6.2)
040
Fig. 6.2
Tight
(both sides)
Wood Parts
2 x
Floor Joist 1-1/4 x 3 x 40-3/4"
060
042
Fig. 6.1
Slide Wall
Assembly
041
041
Flush
S7
x 4 per board
Hardware
8 x
#12 x2" Pan Screw
S7
26
Swing Wall
Assembly
052
051
051
060
Advertisement
