Advertisement
Step 5: Swing Wall Assembly
A: Place (051) Front Wall Panel against the left side of (050) SW Wall Panel noticing panel orientation. The tops
and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten (051)
Front Wall Panel to (050) SW Wall Panel with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 5.1 and 5.2)
B: Place (052) Back Wall Panel against the right side of (050) SW Wall Panel noticing panel orientation. The
tops and bottoms of the panels should be flush and panels square. Pre-drill with a 3/16" drill bit, then fasten
(050) SW Wall Panel to (052) Back Wall Panel to with 4 (WL5) 1/4 x 2-1/2" Wafer Lags. (fig. 5.1 and 5.3)
Fig. 5.2
050
Flush
051
Notice (051) Front Wall
Panel overlaps (050)
SW Wall Panel
WL5
Wood Parts
1 x
SW Wall Panel 1-1/4 x 37 x 92"
050
1 x
Front Wall Panel 1-1/4 x 43 x 92"
051
1 x
Back Wall Panel 1-1/4 x 43 x 92"
052
Fig. 5.1
Hardware
8 x
1/4 x 2-1/2" Wafer Lag
WL5
25
052
WL5
050
Flush
Fig. 5.3
050
Notice (050) SW Wall
Panel overlaps (052)
Back Wall Panel
Advertisement
