Advertisement
Step 15: Swing Post Assembly
Part 1
Note: Keep all bolts from Step 15 series loose
until start of Step 17
A: Place (150) SW Block Angle on top of (151)
Block SW and attach 2 Heavy L-Brackets on top of
(150) SW Block Angle feeding 2 (G17) 3/8 x 6" Hex
Bolts (with 2 flat washers, plastic formed washer and
lock nut) through both boards as shown in fig. 15.1
and 15.2.
B: Attach 3 (WB7) 5/16 x 3" Wafer Bolts (with flat
washer and t-nut) to all three holes in each (152)
SW Post as shown in fig. 15.3. IMPORTANT!
MAKE SURE ALL 6 BOLTS ARE ATTACHED TO
MINIMIZE CHECKING OF WOOD.
C: Place (150) SW Block Angle and (151) Block
SW assembly in between 2 (152) SW Post (Heavy
L-Brackets towards the outside). Place 1 Heavy
C-Bracket on the top (152) SW Post and attach with
(G26) 3/8 x 9-1/4" Hex Bolt (with 2 flat washers and
1 lock nut), as shown in fig. 15.4.
Notice Angle
Orientation
Fig. 15.4
150
3/8" Lock
Nut
3/8" Flat
Washer
152
Wood Parts
1 x
SW Block Angle 2-1/2 x 3 x 15"
150
1 x
Block SW 2-1/2 x 3 x 15"
151
2 x
SW Post 4 x 4 x 92"
152
Heavy C-Bracket
3/8" Flat
Washer
G26
151
Hardware
2 x
3/8 x 6" Hex Bolt
G17
(3/8" flat washer x 2, plastic formed washer & 3/8" lock nut)
1 x
3/8 x 9-1/4" Hex Bolt
G26
(3/8" flat washer x 2 & 3/8" lock nut)
6 x
5/16 x 3" Wafer Bolt
WB7
(5/16" flat washer & 5/16" t-nut)
Fig. 15.1
Bottom View
151
3/8"
Lock
3/8" Flat
Nut
Washer
Fig. 15.2
Top View
Heavy
L-Bracket
151
Fig. 15.3
WB7
x 6
5/16" Flat
Washer
48
Heavy L-Bracket
3/8" Flat
Washer
G17
152
5/16" T-Nut
Other Parts
2 x Heavy L-Bracket
1 x Heavy C-Bracket
150
Plastic
Formed
Washer
Advertisement
