Advertisement
Step 18: Install Ground Stakes
A: In the 5 places shown in fig. 18.1 drive the Rebar Ground Stakes 13" into the ground against (040) Slide End
Panel, on the Front, (091) Diagonal, (024) Rock Rail and both (152) SW Posts. Be careful not to hit the washer
while hammering stakes into the ground as this could cause the washer to break off.
B: Attach ground stakes using 1 (S7) #12 x 2" Pan Screw per ground stake as shown in fig. 18.2.
C: After driving stakes into the ground, check for sharp edges caused by the impact of the hammer. Smooth any
sharp edges from impact area and touch up with outdoor paint.
be driven 13" into ground. Digging or driving stakes can be dangerous if you
do not check first for under-ground wiring, cables or gas lines.
Fig. 18.1
040
Front
SEE FRONT COVER FOR
SAFETY CLEARANCE
MOVE FORT TO FINAL LOCATION PRIOR TO STAKING
FINAL LOCATION MUST BE LEVEL GROUND
Warning!
To prevent tipping and avoid potential injury, stakes must
021
091
5 x
152
Hardware
#12 x 2" Pan Screw
S7
53
F
ig. 18.2
Rebar Ground
Stake
5 x Rebar Ground Stake
S7
Other Parts
Advertisement
