Advertisement
Step 27: Attach Elbow Assembly to Elbow Assembly
Part 1
Note: When installing Pan Bolts make sure to look at holes so bolts go
through the side with the round recess and the lock nuts go through
the side with the hexagonal recess. Keep all bolts loose until further
step.
A: Fit a second Elbow Assembly to the first Elbow Assembly by lining up the
arrows on each assembly. Notice the elbow orientation. (fig. 27.1)
B: Attach 1 TNR2 Slide Clamp Ring to the top of the joined Assemblies
using 3 (PB1) 1/4 x 3/4" Pan Bolts (with lock nut), making sure to match the
arrows up with the end of the clamp ring (where a seam will be) as shown in
fig. 27.2 and 27.3.
Use Quadrex Driver as a guide pin for each hole before inserting bolt.
Do not install bolt
in Clamp Ring ends
until Step 27D
Fig. 27.3
Make sure
arrows are
aligned
Elbow
Assembly
PB1
3 x
PB1
Notice elbow
orientation
Fig. 27.2
Top Slide Bolt Holes
Lock
Nut
Hardware
1/4 x 3/4" Pan Bolt
(1/4" lock nut)
71
Fig. 27.1
Elbow
Assembly
Other Parts
1 x TNR2 Slide Clamp Ring
Advertisement
