Feature Operation; To Login; To Logout - NEC Univerge SV9500 User Manual

FEATURE OPERATION

This chapter describes how to login/logout, how
to input characters and how to make a call/hold,
etc.

TO LOGIN

When login mode is activated, the terminal prompts
for Login ID and Password. When the terminal
starts up with displaying the below screen, the
Login Mode is activated.
1.
When the login mode is activated, the telephone
prompts for Login ID and Password.
2.
Enter the Login
(Station number is usually used as the Login
code.)
3.
Enter a password and press OK.
4.
If the Login ID and password is accepted, display
changes to a normal idle state
Depends on settings, other than the
Favorite screen might be displayed.
For details, please refer to
WHEN THE PHONE
ID and press the
.
"SCREEN
STARTS".

TO LOGOUT

The terminal which is operated with Login Mode can
log out. Logout operation is as follows.
1.
Press the preassigned Logout key on the terminal
The Logout Feature key must be
programmed in advance. For the
programming of the Logout key,
contact the system administrator.
2.
"LOGOUT?" is displayed on the LCD of the
terminal.
3.
Press the Logout on the terminal again.
Set.
55
FEATURE OPERATION