Connecting Headset - NEC Univerge SV9500 User Manual

CONNECTING HEADSET

For DT900 series, 3 types of headset are
available; wired headset, EHS headset, and

Bluetooth headset (DT930 Touch Panel model
only). Following explains about connecting wired
headset and EHS headset cable. About

Bluetooth headset connecting, please refer to
"TO SET Bluetooth

DEVICE".
CONNECTING HEADSET WITH
TERMINAL
According to the following procedure,
Headset is connected to HEADSET
Connector which is located bottom of
terminal.
For the headset that is supported,
please contact the NEC's dealer or
NEC.
The headset which can be connected
to the terminal is "HW510
(A10)/HW251N (A10) (manufactured
by Plantronics)".
HOW TO CONNECT HEADSET
1.
Plug the modular plug of headset into the
HEADSET connector on the bottom of terminal.
2.
Fit the headset cord into the groove to be fixed.
(1)
(1) Terminal
(2) Modular Plug
(3) Cord
(4) Groove Modular Plug
(5) HEADSET connector
Refer to the

HEADSET OPERATION.
(2)
(3)
(4)
(5)
17
INTRODUCTION