Headset Operation; Terminal Operation Using The Headset; Adjusting Headset Ringer Tone Volume - NEC Univerge SV9500 User Manual

HEADSET OPERATION

The table below shows supported headsets and
headset cables for the terminal.
Headset
HW510/HW251N
WT100 Voyager
Legend CS
W710
Voyager 5200

(Bluetooth )
Headset key must be programmed in
advance. For the programming of
Headset key, contact the system
administrator.
TERMINAL OPERATION USING THE
HEADSET
The following procedure explains how to operate a
terminal using the headset. While using the
headset, the operations equivalent to answering
and ending a call are available by pressing the
Headset key.
To Originate a Call
1.
Press the Headset key, and the Headset key lights
red.
2.
Line key lights green and dial tone is received.
3.
Dial a desired telephone number, after the target
party answers the call, you can start a
conversation.
4.
Press Headset key to finish the call, and the
Headset key turns off.
To Answer Call
1.
Press the Headset key while the ringing tone is on,
and the Headset key lights red.
2.
Press the flashing line key to start a conversation
with calling party. Depending on the setting at the
installation stage, you can answer the call by
pressing Answer key instead of line key.
3.
Press Headset key to finish the call, and the
Headset key turns off.
Supported Cable
A10
APN-91
APD80
-
74
To switch to headset mode, press
Headset key during a conversation.
ADJUSTING HEADSET RINGER TONE
VOLUME
You can adjust the ringer tone volume for a headset
in idle/busy status.
The ringer tone can be sent to the
headset by terminal Menu settings.
For the details, refer to
RINGING OF
A ringer tone volume can be adjusted
only for a wired
headset connected to the terminal
headset connector
A ringer tone volume in busy status
cannot be changed when the ringer
tone is set to come from both the
speaker and the headset. For details,
contact the system administrator.
To Adjust the Ringer Tone Volume in Idle Status
1.
Press the Headset key while in idle status to
switch from headset mode to handset mode, and
the Headset key lamp turns off.
2.
Receives as a call from another line.
3.
Press Up/Down cursor key while a ringer tone is
on.
For Ringer Tone Volume in Busy Status
If other lines are accommodated in the telephone as
a subline, and when an incoming call is terminated
to the subline while a call in progress with headset,
the ring tone volume is lower than usual.
When you receive another call during a
call with the headset, the ringer tone
volume for other lines in headset mode
can be set to the same level as the
normal two-way call. For details,
contact the system administrator.
FEATURE OPERATION
"TO SET
HEADSET"