Start The Traffic Meter Without Traffic Restrictions [Router Mode].158 - NETGEAR WAX204 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
Start the traffic meter without traffic restrictions [router
mode]
If the access point is in router mode, you can monitor the traffic volume without setting
a limit on the volume or connection time.
To start or restart the traffic meter without configuring traffic volume or connection
time restrictions:
1. Launch a web browser from a computer or mobile device that is connected to the
access point network.
2. Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Traffic Meter.
The Traffic Meter page displays.
5. Select the Enable Traffic Meter check box.
By default, no traffic limit is specified and the traffic volume or connection time is
not controlled.
6. In the Traffic Counter section, set the traffic counter to begin at a specific time and
date.
7. To start the traffic counter immediately, click the Restart Counter Now button.
8. Click the Apply button.
Your settings are saved.
The Internet Traffic Statistics section helps you to monitor the data traffic. For more
information, see View the Internet traffic volume and statistics [router mode] on page
162.
Maintain and Monitor 158 User Manual