NETGEAR WAX204 User Manual page 132

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
WARNING: To avoid the risk of corrupting the firmware, do not interrupt the upload.
For example, do not close the browser, click a link, or load a new page. Do not turn
off the access point. Wait until the access point finishes restarting and the Power
LED turns solid green.
A progress bar might show the progress of the firmware upload process. The firmware
upload process takes several minutes. When the upload is complete, your access
point restarts.
To verify that the access point runs the new firmware version, continue with the
following steps:
11. Launch a web browser from a computer or mobile device that is connected to the
access point network.
12. Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
13. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
The version firmware is stated in the Firmware Version field at the top right of the page.
Maintain and Monitor 132 User Manual