Change A Service Blocking Rule [Router Mode] - NETGEAR WAX204 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
10. Specify which devices on your LAN are affected by the rule, based on their IP
addresses:
• Only This IP Address. Enter the required address in the fields to apply the rule
to a single device on your LAN.
• IP Address Range. Enter the required addresses in the start and end fields to
apply the rule to a range of devices.
• All IP Addresses. All computers and devices on your LAN are covered by this
rule.
By default, the All IP Addresses radio button is selected.
11. Click the Add button.
The new rule is added to the Service Table on the Block Services page.

Change a service blocking rule [router mode]

If the access point is in router mode, you can change an existing service blocking rule.
To change a service blocking rule:
1. Launch a web browser from a computer or mobile device that is connected to the
access point network.
2. Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Security > Block Services.
The Block Services page displays.
5. In the Service Table, select the radio button for the rule.
6. Click the Edit button.
The Block Services Setup page displays.
Security, Firewall, and Access
Rules
93 User Manual