Change An Ipv4 Static Route - NETGEAR WAX204 User Manual

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
Your settings are saved. The static route is added to the table on the Static Routes
page.

Change an IPv4 static route

You can change an IPv4 static route.
To change an IPv4 static route:
1. Launch a web browser from a computer or mobile device that is connected to the
access point network.
2. Enter http//www.routerlogin.net in the address field.
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Static Routes.
The Static Routes page displays.
5. In the Static Routes table, select the radio button for the route.
6. Click the Edit button.
The Static Routes page adjusts.
7. Change the settings for the route.
For more information about the settings, see Add an IPv4 static route on page 118.
8. Click the Apply button.
The route settings are updated in the table on the Static Routes page.
Network Settings 120 User Manual