NETGEAR WAX204 User Manual page 215

WiFi 6 AX1800 Dual Band Wireless Access Point WAX204
If you are not connected to the access point network but to the same network as the
access point, enter the IP address that is assigned to the access point. If you do not
know the IP address, see Find the IP address of the access point when you cannot
use routerlogin.net on page 27.
A login window displays.
If your browser does not display the login window but displays a security message
and does not let you proceed, see Log in to the access point after initial setup on
page 30.
3. Enter the access point local device password.
The local device password is the one that you specified. The local device password
is case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Port Forwarding / Port Triggering.
The Port Forwarding / Port Triggering page displays.
5. Select the Port Triggering radio button.
The port triggering settings display.
6. Click the Add Service button.
The Port Triggering - Services page displays.
7. Set up a new port triggering rule with a custom service or application by specifying
the following settings:
• Service Name. Enter the name of the custom service or application.
• Service User. From the Service User menu, select Any, or select Single address
and enter the IP address of one computer:
- Any. This is the default setting and allows any computer on the Internet to
use this service.
- Single address. Restricts the service to a particular computer. Enter the IP
address in the fields that become available with this selection from the menu.
• Service Type. Select the protocol (TCP or UDP) that is associated with the service
or application.
• Triggering Port. Enter the number of the outbound traffic port that must open
the inbound port or ports.
Port Forwarding and Port
Triggering [Router Mode]
215 User Manual