Set A Static Ipv4 Address - NETGEAR WAX220 User Manual

Essentials WiFi 6 AX4200 Dual Band Multi-Gig Access Point Model WAX220

Set a static IPv4 address

By default, the DHCP client of the AP is enabled, allowing a DHCP server (usually, a
router) in your network to assign an IPv4 address to the AP. You can disable the DHCP
client and set a static (fixed) IP address for the AP.
To set a static IPv4 address for the AP:
1. Launch a web browser from a computer or tablet that is directly connected over WiFi
to the AP or connected to the same network as the AP.
2. Enter the IP address that is assigned to the AP.
If you are directly connected to the management WiFi network, you can enter
https://www.aplogin.net.
A login page displays.
If you do not know the IP address, see Find the IP address of the AP on page 24. For
more information about the management WiFi network, see Management WiFi
network on page 43.
If your browser displays a security warning, you can proceed, or add an exception
for the security warning. For more information, see kb.netgear.com/000062980.
3. Enter the AP login password and click the LOGIN button.
The AP login password is the one that you specified the first time you logged in to
the AP. The password is case-sensitive.
The Dashboard page displays.
4. Select Management > Network > Basic.
The IPv4 Settings page displays.
5. Select the Static IP radio button.
The IPv4 address fields display.
6. Set the static IPv4 address, subnet mask, gateway IPv4 address, and primary and
secondary DNS addresses.
7. Click the Apply button.
A pop-up window displays.
8. Click the OK button.
Your settings are saved.
Note: To log back in to the AP, you now must use the static IP address that you assigned.
Manage the Wired Network
Settings
29 User Manual