Advertisement
Command Summary
The following tables summarize the special
commands available when using the dome in a
Manchester network. These commands are
available when you enter the number listed and
press the Set Preset or Call Preset button on the
controller. Refer to the instructions in this
document for specific information about using the
commands.
Set Commands: This table describes the
functions that can be performed when you enter
the number listed then press the Set Preset button.
Command
65 Set Preset
Reset Dome
66 Set Preset
Starts Dome Configuration Menu
67 Set Preset
Activate / Deactivate V-phase
delay setting adjustment
68 Set Preset
Cancel Pattern Programming
69 Set Preset
Save Pattern Programming
70 Set Preset
Program Pattern 1
71 Set Preset
Program Pattern 2
72 Set Preset
Program Pattern 3
Call Commands: This table describes the
functions that can be performed when you enter
the number listed then press the Call Preset button.
Command
66 Call Preset
Resume Auto Focus / Auto Iris
67 Call Preset
Rotate dome 180 from current
position ("flip")
69 Call Preset
Repeats following pattern
70 Call Preset
Run Pattern 1
71 Call Preset
Run Pattern 2
72 Call Preset
Run Pattern 3
Working with Presets and
Patterns
This section describes how to program and call the
presets and patterns supported by the dome.
Defining Presets (Shots)
Presets, also called shots or targets, are
programmed video scenes, based on specific pan,
2
MANCHESTER USER INSTRUCTIONS
Function
Function
tilt, zoom and focus settings. The dome supports
up to 64 presets when used on a Manchester
network.
To program presets, do the following:
1. Ensure that your camera controller is in
programming mode. Refer to your controller
documentation for additional information.
2. Adjust the position of the dome until you see
the scene that you want to program. Adjust the
zoom, focus, and iris settings if necessary.
3. Use the numeric keypad on the camera
controller to enter the number (1-64) of the
preset you are programming, then press Set
Preset.
For example, to program Preset 12, you would
press, 1 , 2 , then Set Preset.
Calling Presets
To display the preset, do the following:
1. Select the monitor where you want the preset
appear.
2. Use the numeric keypad on the camera
controller to enter the preset number (1-64),
then press Call Preset.
Defining Patterns
A pattern is a sequential series of pan, tilt, zoom,
and focus movements from a single programmable
dome. You "teach" the dome a combination of
these movements that can be replayed
automatically. The dome supports up to three
patterns using presets 70, 71, and 72. To program
a pattern, do the following:
1. Ensure that your camera controller is in
programming mode. Refer to your controller
documentation for additional information.
2. Move the dome to the starting point of the
pattern. Adjust the zoom, focus, and iris
settings if necessary.
3. Use the keypad to enter the number associated
with the pattern ( 70 , 71 , or 72 ), then press Set
Preset.
4. Move the camera around to create the pattern.
Note : If you make a mistake while
programming the pattern, enter 68 , then press
Set Preset. This ends the pattern without saving
it. Return to step 1 to start programming again.
5. When you complete the pattern, press 69 , then
Set Preset to save the pattern.
DELTADOME PROGRAMMABLE SURVEILLANCE CAMERA
8000-2614-01, REV. B
Advertisement
