Pattern And Preset Camera Controls; Procedure 3-5 Zooming A Dome Via The Mouse Scroll Wheel; Procedure 3-6 Selecting A Dome Pattern Using The Live Video Page; Procedure 3-7 Defining A Dome Pattern Using The Live Video Page - American Dynamics IP SpeedDome Ultra 8 Configuration And User's Manual

Zoom via Mouse Scroll Wheel
Procedure 3-5 Zooming a dome via the mouse scroll wheel using the Live Video
page
1 Point the camera at a target.
2 Scroll the mouse wheel forwards (zoom in) and backwards (zoom out).

Pattern and Preset Camera Controls

A Preset is a pre-positioned camera scene that you program for cameras installed with pan/tilt and
motorized lens capability. A Pattern is a sequence of pan, tilt, zoom, focus and iris movements
from a single, programmable dome. The dome learns these movements during programming for
later execution.
Note
Only Presets and Patterns that have been set up for the particular camera can be selected. Use
Intellex, Network Client, a Touch Tracker, or the Live View page to program presets and patterns.
Selecting a Pattern

Procedure 3-6 Selecting a dome pattern using the Live Video page

1 Click to open the Primary Camera Control menu.
2 Click Pattern for the pattern menu:
3 Select a pattern number.
4 Click to run the pattern once or
5 Click Exit to close the Pattern menu.
6 Click to close the Primary Camera Control menu.
Defining a Pattern

Procedure 3-7 Defining a dome pattern using the Live Video page

1 Click to open the Primary Camera Control.
2 Position the camera for the pattern's start position.
3 Click and select an index for pattern.
4 Click Define Pattern
It resembles the Primary Camera Control menu, except for Start and Stop.
5 Click Start to begin programming the pattern. Use any displayed controls to define the
pattern's behavior.
to run the pattern continuously.
. The Pattern Definition Menu appears.
Web Configuration
3-9