Adjusting The Camera Position; Adjusting The Zoom & Focus (Vari-Focal) / Default & Reset Button - American Dynamics Illustra Flex 1MP Quick Start Manual

2.2.4 Adjusting the Camera Position

1. Use the cross screwdriver loosen the cross screw on one side of the mount bracket so that you can tilt
the camera.
2. Loosen the screw on the retainng ring to adjust the camera angle.
3. After adjustments, fasten the screws and retaining ring back to the camera.
2.2.5 Adjusting the zoom & focus (vari-focal) / default & reset button
1. Use a screwdriver to adjust the Near/Far and Tele/Wide controls. Please be careful when adjusting
Near/Far and Tele/Wide so as to avoid damage to the lens.
2. Use a flat head screwdriver to open the cover, then user can press default button to factory setting or
reset button to reboot system.
Caution After ajustment, tighten the screws to avoid water leaking issue.
Retaining ring
F 2-5: A
IGURE DJUSTING THE
Tele/Wide control
F 2-6: A
IGURE DJUSTING THE
Cross screw
C P
AMERA OSITION
Default/Reset (inside)
Z & F (V -F
OOM OCUS ARI OCAL
12
Illustra Flex 1MP & 3MP Bullet
Near/Far control
)