ROSIERES FE 5143 RU Instructions For The Use And Installation page 21

* Introduction
The pointer "C" allows
you to :
.
show the start time of a
cooking programme or a py-
rolyse cycle (shown here at
11 o' clock).
Window showing :
: End of cooking
: Manual position
Between 0 and 180 minutes:
cooking time
CLOCK
The time of day should be set before using the oven.
Setting the time of day :
To set the time of day, pull button "B" of the programmer until the exact time is displayed, then release the button.
TIMER
The timer can be used as a reminder, independently of the oven. An alarm sounds at the end of the set programme.
It has no effect on the oven functionning. For that, leave the thermostat and selector control knob on "Off".
- Turn button "A" to the right to display a cooking time.
- Turn the oven control and thermostat knobs to off.
The timer will start to count down.
At the end of the set progamme an alarm sounds. To stop it, turn back button "A" until the
window.
BEFORE DOING ANY COOKING, THE MANUAL POSITION AND A COOKING TIME WITH OR WITHOUT
DEFERRED START SHOULD BE DISPLAYED ON THE PROGRAMMER.
THE PROGRAMMER
Button "A" :
*
turning the button in a clockwise di-
rection allows you to display the
following in the little window :
. the manual position and either,
. a cooking time (between 0 and 180
mins).
. or the "end of cooking" symbol.
*
pulling the button and turning it in a
clockwise direction : allows you to po-
sition the pointer "C" for a deferred
start.
When not using a deferred start
programme, the pointer "C" should
always be positioned beneath the
small hand of the clock.
Button "B" :
*
pulling and turning this button in a
clockwise direction : allows you to al-
ter the time shown on the clock.
symbol appears in the little
GB
- 21