Automatic Measurement - Tenma 72-14520 Instructions Manual

AUTOMATIC MEASUREMENT

• Press the MEASURE button to enter the automatic measurement menu.
Functions
Signal source
All parameters
User defined
Measurement
Statistical Analysis
Next page
Signal source
Indicator selection
Indicator
Clear
Return
All Parameters Measurement
• Press MEASURE key to enter automatic measurement menu then F1 to select the
source. F2 can be used to select all 34 parameters.
• Measured parameters colour are consistent with the current channel.
When "----" is shown, it indicates that the current source has no signal input, or the
measurement result is not valid (too big or too small).
Options
CH1 to CH4 Select the data source from any one of the channels
ON Close all Parameters
OFF Pop-up window with all parameters is displayed
Open/Close menu for user defined parameters. When it is
on, define all parameters required with the Multi-purpose
ON/OFF
control. It can customize and display up to 5 parameters at
the same time.
OFF Turn OFF feature
Peak Automatic calculation of user defined parameters of
average, max, and min. Only applicable when user defined
parameters are present.
Difference Automatic calculation of user defined parameters of average,
difference, and number of measurements. Only applicable
when user defined parameters are present.
Go onto the next page
CH1 to CH4 Select the data source from any one of the channels
Using the Multi-purpose control, up to 34 parameters can be
selected.
ON Open parameter indicator
OFF Close parameter indicator
Clears all parameters
Return to automatic measure main menu
Description
33