Simple Measurement - Tenma 72-10175 User Manual

TENMA 72-10175
DIGITAL OSCILLOSCOPE

Simple Measurement

To acquire and display a signal, follow these steps:
1. Connect signal to CH1 by using probe
2. Click the "AUTO" button on toolbar or " Acquire -> Auto Setup " on menu.
The Tenma set the vertical, horizontal, and triggers controls at the best status automatical
ly. Also, you can adjust the controls to meet your measurement to optimize the waveform
display.
To measure the frequency and "Vpp ", follow these steps:
1. Click the "Measure->Horizontal->Frequency" button, the frequency of the signal
display on the bottom of the waveform interface.
2. Click the "Measure->Vertical->Peak-to-Peak" button, the "Vpp" of the signal will also
display on the bottom of the waveform interface.
3. To clear the measurement on the waveform interface, click the "Measure->Clear
Measure" button.