Slope Trigger - Tenma 72-14520 Instructions Manual

Edge type
Pulse Condition
Polarity
Pulse width range
Slope Condition
Time Setup
Signal System
Frequency Range
Cursor
Auto measurement
Measurement
number
Measurement
range
Measurement
statistics
Frequency meter
Setting
Waveform
Bitmap
Edge Trigger
Rising, falling, any
Pulse Width Trigger
>, <, =
Positive, negative pulse width
4ns ~ 10s

Slope Trigger

Positive slope (greater than, less than, specified range)
Negative slope (greater than, less than, specified range)
8ns~10s
Video Trigger
Supports NTSC, PAL and SECAM systems, rows range is 1~525 (NTSC)
and 1~625 (PAL/SECAM)
Voltage between cursors (▲V)
Manual Time between cursors (▲T)
Frequency (Hz) (1/▲T)
Trace Mode Voltage and time at waveform point
Indicator Allows auto display of cursor
Max, Min, Peak-Peak, Top, Bottom, Amplitude, Mean, Middle, Period
Mean, RMS, Period RMS, Area, Period Area, Overshoot, Preshoot,
Frequency, Period, Rise Time, Fall Time, Positive Pulse, Negative Pulse,
Positive Duty Ratio, Negative Duty Ratio, Delay A->B, Delay A->B, Delay
B->A, Delay B->A.
Displays 5 at the same time
Screen or cursor
Average value, maximum value, minimum value, standard deviation and
the number of measurements
6-bit
Internal (256), External USB
Internal (256), External USB
External USB
Measure
Storage
46