System Upgrade - Tenma 72-14520 Instructions Manual

Functions
Operation
Stop setting
Template setting
2/2
• After opening the pass test, you are required to set the stop settings and template
settings before you can perform the test function. Otherwise you'll be prompted
"Function is Disabled".
• Stop settings menu.
Functions
Stop type
Condition
Threshold
Return
• Template settings menu.
Functions
Reference
waveform
Horizontal
tolerance
Vertical tolerance
Create template
Return

SYSTEM UPGRADE

• Press UTILITY to enter the auxiliary function menu, press F1 to view system
information, access the machine's model number, software, and hardware version
information.
• Having downloaded the latest version consistent with the oscilloscope model, place
the file on the root directory of a USB drive inserted into the oscilloscope USB port.
• Press UTILITY to enter the auxiliary function menu then press F5 twice to enter
page 3 menu then press F1 to select system upgrade.
• Press F1 again to confirm.
• The upgrade process takes a few seconds then the oscilloscope will power off and
restart automatically to complete the process.
• Do not disconnect the power supply during this process or interrupt it otherwise
damage may occur to the oscilloscope.
Options
Close Disable Pass Test
Open Enable Pass Test
Enters Stop Settings Menu
CH1 to CH4 Enters Template Settings Menu
Enter Pass Test menu
Options
The test function stops after it reaches a specified pass
Pass count
count number
The test function stops after it reaches a specified fail count
Fail count
number
>=,<= Stop condition setting
Use the multi-purpose control to select the stop condition
threshold
Return to previous menu
Options
Select a channel CH1~CH4 with horizontal and vertical
CH1 to CH4
tolerance as template
Use the multi-purpose control to select the horizontal
1~255
tolerance
1~255 Use the multi-purpose control to select the vertical tolerance
Create template with above conditions
Return to previous menu
Description
Description
Description
41