Table of Contents
Advertisement
5500 Series Power Operator - PUSH SIDE Installation
Prepare Frame and Door for PUSH Side Installation
Become familiar with operator components and fasteners. It is recommended that components remain in box
until installed. Verify there is minimum ceiling clearance for operator installation before proceeding. (Figure 1)
A. Prepare frame for operator.
1 .
Verify frame reveal width is 2-5/8"-6-3/4"
(67mm-171mm) . (Figure 1)
NOTE: If frame reveal is less than 3" (76mm),
arm adjusting rod can be field cut to 9-1/2"
(241mm) measured from centerline of
connecting link bushing assembly.
2 .
Determine if push or pull and if left hand or right
hand installation . (Figure 2)
NOTE: These steps are for PUSH side only.
3 .
Frame header MUST be flat / without twists.
Backplate of operator can be used as reference .
NOTE: If frame is not flat or is twisted, an
additional steel back plate or shimming is
required. Failure to mount unit properly can
result in improper function of operator.
4 .
Using detailed template on page 15, prepare four
(4) holes for 1/4-20 x 1/2" machine screws or
#14-10 x 2-1/2" wood screws . Blind rivet nut (by
others) is suggested for unreinforced hollow
metal or aluminum frames . (Figure 3)
5 .
For concealed mounted conduit (if applicable):
Prepare two (2) 7/8" (22mm) diameter holes
for conduit, for power input and for switch/
sensor wires .
NOTE: On new construction, these holes will
generally be drilled by frame supplier at their
shop or at time-of-install.
Door Opening Angle
Up to 110°
111° to 170°
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9355-0007-020 Rev 1 03/21
Dim B
15-3/4" (400mm)
13-1/4" (337mm)
Left Hand Shown
Figure 3
Approved 2021-04-16
1-1/2" (38mm)
Min. Frame Face
Frame Reveal
Figure 1
Left Hand
PUSH
Figure 2
B
13-3/4
(349)
11-5/8
(295)
1-1/4
(32)
Ø7/8
Frame
2x
(23)
Rabbet
Frame
L C Hinge or Pivot
Stop/Soffit
5- / " (13 mm)
3 8
7
Min. Ceiling
Clearance
Door Thickness
1-3/4" (44mm) Min.
2-1/4" (57mm) Max.
Pull Side
Push Side
Right Hand
PUSH
13-1/16
(332)
7-5/8
(194)
3/4
1/2
(19)
(13)
1/4-20 Machine Screw or
No 14-10 Wood Screw (4x)
5
Advertisement
Table of Contents
