Table of Contents
Advertisement
5500 Series Power Operator - PUSH SIDE Installation
Attach Cover and Label to finalize installation
1 .
Align cut-outs in cover to pinion shafts . (Figure 18)
2 .
Slide cover onto unit .
NOTE: Verify all wiring is inside cover.
3 .
Secure cover to backplate with six (6) cover screws .
NOTE: If cover will not securely install onto
unit, verify backplate is not warped or twisted.
Additional support or shimming may be required.
See Sections A & B under Prepare Frame and Door.
4 .
Attach Norton label to front of cover approximately
1/2" (13mm) from side and bottom edges .
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
80-9355-0007-020 Rev 1 03/21
WARNING: Make sure no wiring is loose or can be
caught by cover when it is snapped into place.
Approved 2021-04-16
Pinion Shaft Cut-out
Cover Screw
Label
Figure 18
11
Advertisement
Table of Contents
