Table of Contents
Advertisement
Before You Begin
•
All dimensions are given in inches (millimeters) .
DO NOT scale drawings .
•
Thickness recommended for reinforcements in
hollow metal doors and frames is charted .
•
Template information is based on use of 5"
(127mm) maximum width butt hinges or 3/4"
(19mm) offset pivots .
•
Frame reveal is between 2-5/8" and 6-3/4" (67-
171mm) for PUSH units .
•
Before beginning the installation, verify that the
door frame is properly reinforced and is well
anchored in the wall . Frame header must be
straight - without warp or bow .
•
Unreinforced hollow metal frames and
aluminum frames should be prepared and
fitted with 1/4-20 blind rivet nuts, furnished by
others .
•
Concealed electrical conduit and concealed
switch or sensor wires should be pulled to the
frame before proceeding .
Fasteners for Frame:
•
Hollow metal and aluminum:
1/4-20 x 1/2" Phillips Pan Head Machine screws
•
Wood:
#14 -10 x 2-1/2" Phillips Pan Head Wood screws
Fasteners for Door (Push Side Mounting):
•
1/4-20 x 2" Sex Nut and Bolt
4
Mounting Hardware
Unit:
#14-10 x 2-1/2"
Unit:
1/4-20 x 1/2" PPHMS
Arm:
1/4-20 x 2" Sex Nut and Bolt (SNB)
Approved 2021-04-16
5500 Series Power Operator - PUSH SIDE Installation
Templating based on 1/8" gap
between door and frame.
Hollow Metal Door Frame Reinforcing
Frame Material
Recommended
12 Ga.
.105
(2 .66)
14 Ga.
.075
(1 .90)
16 Ga.
.060
(1 .52)
18 Ga.
.048
(1 .21)
Door or Frame
Wood
PPHWS
Hollow Metal or
Aluminum
Hollow Metal
Aluminum or Wood
Copyright © 2021, ASSA ABLOY Accessories and Door Controls Group, Inc. All rights reserved. Reproduction in whole or
in part without the express written permission of ASSA ABLOY Accessories and Door Controls Group, Inc. is prohibited.
Frame
Door
1/8"
(3)
Reinforcing
Min . Required
12 Ga.
18 Ga.
.105
.048
(2 .66)
(1 .21)
10 Ga.
12 Ga.
.134
.105
(3 .41)
(2 .66)
10 Ga.
12 Ga.
.134
.105
(3 .41)
(2 .66)
8 Ga.
10 Ga.
.164
.134
(4 .18)
(3 .41)
Drill
3/16" (4 .76mm)
Drill #7 ( .201 dia . or 5 .10mm)
Tap 1/4-20
9/32" (7 .00mm) thru
3/8" (9 .50mm) door face opposite
to closer
3/8" (9 .50mm) thru
80-9355-0007-020 Rev 1 03/21
Advertisement
Table of Contents
