Temperature Alarms And Trips Screen - Johnson Controls YORK OM Titan Operating Instructions Manual

FORM 160.72-O1 (810)

TeMperaTure alarMs and Trips sCreen

figure 32 - TEMPERATURE ALARMS AND TRIPS SCREEN
overvieW
This screen is the first of two displays for the tempera-
ture alarms and trips. Each point has either an alarm
(warning) or a trip (shutdown) or both. These points
will be configured at commissioning by a qualified
Johnson Controls Service Technician.
displaY onlY
Motor Blind end Bearing high Temperature
Displays the High Bearing Temperature alarm and trip
point for the Blind end of the motor, if the sensors are
present and enabled.
Motor shaft end Bearing high Temperature
Displays the High Bearing Temperature alarm and trip
point for the Shaft end of the motor, if the sensors are
present and enabled.
gearbox high speed Blind end Bearing high
Temperature
Displays the High Bearing Temperature alarm and trip
point for the Blind end of the high speed gear, if the
sensors are present and enabled.
JOHNSON CONTROLS
gearbox high speed shaft end Bearing high
Temperature
Displays the High Bearing Temperature alarm and trip
point for the Shaft end of the high speed gear, if the
sensors are present and enabled.
gearbox low speed Blind end Bearing high
Temperature
Displays the High Bearing Temperature alarm and trip
point for the Blind end of the low speed gear, if the sen-
sors are present and enabled.
gearbox low speed shaft end Bearing high
Temperature
Displays the High Bearing Temperature alarm and trip
point for the Shaft end of the low speed gear, if the sen-
sors are present and enabled.
Compressor shaft end high oil Temperature
Displays the High Oil Temperature alarm and trip point
for the Shaft end of the compressor.
3
81