Installation Of Battery Compartment; The Battery Door; Installation Of Battery Door - Philips TeleMon B M2636B Service Manual

Repair
Step 3.
Installation of Step 1.
Battery
Step 2.
Compartment
Step 3.
Step 4.
Step 5.
Step 6.
The Battery
Door
Removal of
Step 1.
Battery Door
Step 2.
Installation of Step 1.
Battery Door
5-46 Troubleshooting, Service and Repair
Hint— The Battery Door must be open, and the serial port door must have been
removed.
Remove the pin holding the Battery Connector to the compartment.
Stand the Rear Housing up with the open side facing you.
Open the battery door on the housing, if necessary.
Attach the Battery Connector to the Battery Compartment with the pin. Make sure
that the wires face up.
Place the Battery Compartment in the bottom of the Rear Housing through the front,
making sure the cable is on the left. The left side of the film pocket must go over the
left side of the Battery Compartment.
Place the Rear Housing on its back.
Fasten the four feet to the bottom of the case with four 8mm T-10 screws. The cut-
outs in the feet must face the inside.
Tighten the screws only until snug. Do not overtighten.
Caution—
Figure 5-18 The Battery Door
Make sure the Battery Door is open and is in a horizontal position.
Push the Battery Door post closest to the open side of the Rear Housing. The door
falls out.
Placing the Battery Door in a horizontal position under the battery port, hook the
door post closest to the back of the TeleMon into the slot provided.