Table of Contents
Advertisement
Repair
Note—
run outward over the top of the dock.
The Fan
Assembly
Removal of
Step 1.
Fan Assembly
Step 2.
Step 3.
Note—
bonded.
Installation of
Step 1.
Fan Assembly
Step 2.
Step 3.
Step 4.
Step 5.
The Splash
The splash guard helps protect the internal components of the TeleMon.
Guard
Removing the
If necessary, remove the old splash guard by carefully pulling the guard away from the
Old Splash
TeleMon housing. You should do this with no other components attached to the rear housing.
Guard
Installing the
Step 1.
New Splash
Step 2.
Guard
5-48
Troubleshooting, Service and Repair
Before you insert the fasteners, make sure the Fan-to-Main Cable and the NBP Tubing
If the NBP Tubing is in place, remove it from the supporting channel of the Speaker
Mount.
Remove the two 14 mm T-10 screws from the top of the fan housing and the one 6
mm T-10 screw from the exhaust conduit.
Lift and slide the Fan Assembly out over the reflective surface of the Speaker
Mount.
Do not attempt to pry the fan housing from the exhaust conduit, to which it has been
With an alcohol swab, wipe away any dust or lint that have accumulated on the Rear
Housing or vent.
Insert the Fan Assembly over the top of the reflective surface of the Speaker Mount
and hold it so that the holes are aligned with the screw mounts.
Fasten Fan Assembly to the screw mounts with two 14 mm T-10 screws through the
top of the fan housing and one 6 mm T-10 screw through the exhaust conduit.
Hint—
Replace the 6mm screw first.
Replace the NBP Tubing in the supporting channel of the Speaker Mount.
Insure that the Fan-to-Main Cable runs over the top of the NBP Tubing.
Remove the adhesive protector from the middle portion ONLY of the guard.
Align edge of adhesive with top edge of rear housing and press into place. Note that
the plastic extends beyond the housing. No adhesive, however, should be exposed
beyond the housing.
Advertisement
Table of Contents
Troubleshooting
