Entering Demo Mode; Change Date & Time, Display Contrast; Viewing Transmitter Information - Philips TeleMon B M2636B Service Manual

Caution
Current settings will be lost when standard unit settings are restored.
Step 2.
Step 3.
Step 4.
Entering Demo
Demo mode facilitates learning how to use TeleMon. It shows sample wave forms for a 5-
Mode
lead transmitter and helps you familiarize yourself with the controls.
Note that no EASI measurements are available in Demo Mode, and that the ECG wave form
has a drop-out every 60 seconds. No transmitter is required to run the demo.
Warning Warning
If the transmitter is docked to TeleMon while in Demo Mode, the transmitter continues
to transmit information to the Information Center, but that information doesn't display
on TeleMon, nor does the demo data go to the Information Center. While in Demo Mode
TeleMon displays only the pre-programmed demonstration.
Step 1.
Step 2.
Change Date &
This selection allows you to change the contrast of the display to better suit your viewing
Time, Display
conditions. It also allows you to verify or change the date and time.
Contrast
To adjust the display contrast or work with the date and time, follow these instructions.
Step 1.
Step 2.
Step 3.
Step 4.
Viewing
This selection allows you to view the current settings of the docked transmitter.
Transmitter
To view the transmitter information, follow these steps.
Information
Step 1.
Step 2.
Step 3.
Press Go.
Press Accept or Cancel at the confirmation dialog box.
If you press Accept, a message appears when the restore completes.
Press Done to return to the Device Setup menu.
To activate Demo Mode, select Enter Demo Mode from the Device Setup Menu.
To exit Demo Mode, turn the monitor OFF.
From the General Configuration Menu, select Date & Time, Display Contrast.
Press Go.
Select either Adjust Display Contrast or Set or Verify Time and Date.
To adjust the display contrast: Use the arrow keys to adjust the contrast. The screen
sample displays the result of the selection. Press Done.
To set the date and time: Use the arrow keys to adjust each number and use the
Next Setting key to move among fields. Press Done after you complete the
changes.
From the General Configuration Menu, select View Transmitter Information.
Press Go.
Press View SpO2 Hardware to view the SpO2 hardware information.
Troubleshooting, Service and Repair
Service Mode
5-13