Cloning Settings - Philips TeleMon B M2636B Service Manual

Step 12. When the upgrade is complete, you can turn TeleMon OFF and remove the cable.
Step 13. Replace the upgrade port door and turn TeleMon ON. The application installation
Step 14. Verify that the TeleMon software version in the boot screen matches the version of
Step 15. Verify that the time and date are properly set.
Cloning
The Clone TeleMon Settings function of the Support Tool allows you to configure other
Settings
TeleMon monitors with identical settings. Using the Support Tool, you can retrieve
configuration settings from a monitor, create a new configuration file, or open a configuration
file. You can also print a configuration file for later reference.
Before you can use the cloning software, you must prepare your computer as described in the
section "Setting Up the Host Computer" on page 5-20.
To use the support software to clone settings, follow these steps:
Step 1.
Step 2.
Step 3.
Step 4.
Step 5.
Note—
only. You cannot change any settings on this screen.
Creating and Using a New Configuration
If you are creating a new configuration, adjust the settings and either save them or send them
to the TeleMon. If there are any settings in the fields, click New Configuration to clear all
fields.
To send the settings to the TeleMon, click the Send Configuration button.
To save the settings, click Save Configuration.
Retrieving a Saved Configuration
If you want to use a previously saved configuration, click Open Configuration and open the
configuration file you want to use.
You can edit a saved configuration file and save it with a different name if you want to keep
the older configuration file.
Retrieving a Configuration from TeleMon
If you want to retrieve a configuration from a TeleMon, click Get Configuration. You can
then make changes, save the configuration, or send the configuration to other TeleMon
monitors.
– A progress bar indicates the status of the upgrade.
process is now complete.
the software on the CD-ROM.
Connect one end of the serial cable to your computer.
Power on TeleMon and connect the serial cable to TeleMon when the self-test
screen displays.
Start Active Sync if it is not already running.
You are prompted to start Active Sync if it is not running when you try to retrieve or
send settings.
Start the TeleMon Support Tool.
Click Clone TeleMon Settings.
The Clone TeleMon Settings window displays.
The Clone Settings selection on the TeleMon monitor displays an information screen
Troubleshooting, Service and Repair
Service Mode
5-25