Philips TeleMon B M2636B Service Manual page 92

Number Description
M2636-40008 Pre-formed plastic part. The door covering the serial
upgrade port, visible through an opening in the bottom of
the Rear Housing.
M2636-60100 Assembly consisting of pre-formed plastic case, display,
antiglare panel, keyboard and keyboard overlay.
M2636-60101 Splash guard kit consisting of plastic film with adhesive.
M2636-60102 Kit of extra screws required for reassembly. Consists of:
Screw used for monitor assembly.
Screw used for monitor assembly.
Screw used for monitor assembly.
Screw used for monitor assembly.
Screw used for monitor assembly.
Screw used for monitor assembly.
M2636-60110 Ribbon cable between the LCD and the Main Board. Splits
at one end. Three integral connectors.
M2636-60120 Runs between the Inverter Board and the LCD. Integral
connectors on each end.
M2636-60130 Runs between the NBP Board and the Main Board. Integral
connectors on each end.
M2636-60140 Power cable running between the transmitter and the Main
Board. Integral connector on each end.
M2636-60302 A PC board mounting the electronics and the cuff pump for
non-invasive blood pressure (NBP) measurements.
Note—
versions of the TeleMon software and hardware.
M2636-60301 The air conduit tubing, mount, and collar connector.
M2636-60412 Device for reconditioning the battery.
M2636-60500 10.8-volt, rechargeable NiMH.
M2636-68200 A PC board mounting ICs and other electrical components,
containing the TeleMon's major electronics (exchange
assembly).
M2636-90035 TeleMon Release B User and Service Documentation (CD-
ROM).
7-2 Parts List
The new NBP module is compatible with older
Part
Serial Upgrade Door
Front Panel Assembly
Splash Guard Kit
Screw Kit
M3.0x8mm Torx T-10
M2.0x4mm Torx T6
M3.0x14mm Torx T-10
M3.0x6mm Torx T-10
M3.0x4mm Torx T-10
M3.0x16mm Torx T-10
LCD Data Cable
Inverter-to-LCD Cable
NBP-to-Main Cable
Transmitter-to-Main Cable
NBP Board Assembly
NBP Connector Assembly
Battery Conditioner
Internal Battery
Main Board
User and Service Documentation
CD