Table of Contents
Advertisement
Note—
All the connectors on the Main Board are keyed to the appropriate cable connector. Do
not force a connector. If it does not easily fit, it is the wrong connector.
Step 1.
Stand the Rear Housing Assembly up on the work surface, facing you.
Step 2.
Align the Chassis Assembly flat on the work surface before the Rear Housing
Assembly, with the Main Board up and the NBP Board closest to you.
Step 3.
Fit the flange on the bottom front of the Battery Compartment between the Chassis
and the Main Board.
Step 4.
Press the connector of the Transmitter Power Cable into the keyed connector on the
Main Board.
Step 5.
Press the connector of the Speaker-to-Main Cable into the keyed connector on the
Main Board. You may have to tilt the Chassis Assembly up a little.
Step 6.
Tilting the Chassis Assembly up, press the Battery-to-Main Cable connector into the
keyed connector at the left side of the Main Board.
Caution
Make sure that when the Chassis Assembly is tilted into place, the cable folds into the
pocket formed by the fold in the battery connector film (attached to the Speaker
Housing).
Step 7.
Twist the two halves of the NBP Tubing Collar Connector together until they snap-
lock into place. Hook the tubing behind the top of the Speaker Clip.
Step 8.
Running the Fan-to-Main Cable over the top of the NBP Tubing, press the
connector into the keyed connector on the Main Board.
Step 9.
Holding the Chassis Assembly, lay the Rear Housing Assembly on its back on the
work surface.
Step 10. Starting from the left side, so that you can insert the power switch on the Main
Board into the appropriate opening in the Rear Housing Assembly, insert the
Chassis Assembly into the Rear Housing Assembly.
Note—
With your finger, insure that the Fan-to-Main Cable bows to the left, out of the
way of the transmitter optical path.
Step 11. Aligning the screw holes in the Chassis with the screw mounts on the Rear Housing
Assembly, fasten the Chassis Assembly to the Rear Housing Assembly with four
6mm T-10 screws.
Place the most accessible screws first.
Hint—
Step 12. Be sure no ribbon cable protrudes beyond the Display on the left side of the Monitor
Assembly, adjusting the position of the cable and/or Chassis Assembly, if
necessary.
Troubleshooting, Service and Repair
Repair
5-37
Advertisement
Table of Contents
Troubleshooting
