Mounting On A Pole; Use Of Pole Clamp With Monitor - Philips TeleMon B M2636B Service Manual

Mounting on a Pole

Mounting on an IV pole combines mobility with stability. The External Power Supply can be
mounted apart or near the TeleMon on the same pole. For example, mount the power supply
at the bottom of the IV pole.
Note—
avoid seepage of spills into the plug on the other side ( Figure 4-2 ).
For pole mounting, use the Pole Clamp, Part Number 5061-8363, which can support a
maximum load of 14 pounds (6.5 kg).
Use of Pole
Step 1.
Clamp with
Monitor
Step 2.
Step 3.
The power input cord must run from the TOP of the power supply to the monitor, to
Figure 4-1 Mounting TeleMon with Pole Clamp
Screw the Dovetail to the rear surface of the Pole Clamp, using the screws provided
with the Dovetail. Two alignments are available, horizontal and vertical.
Fasten the Pole Clamp to the supporting rail or pole. Use your judgement to
determine the most stable and solid method of mounting.
Slide the NBP Cuff Holder on the back of the TeleMon down over the Dovetail
until the latch snaps.
Note— To remove the monitor, slide your finger under the TeleMon and push the latch
at the back, which is on the Dovetail.
Mounting on a Pole
Installation 4-3