Suspending Patient Alarms; Task Summary; Information Messages - Philips TeleMon B M2636B Service Manual

Suspending
You can suspend central telemetry alarms from TeleMon for 3 minutes to prevent false alarms
Patient Alarms
from occurring during a change of electrodes or other activity that could cause motion artifact
alarms.
Visual Indicators on TeleMon for Suspended Alarms:
•
•
•
Note—
operation; that is, suspend is enabled at central.

Task Summary

To suspend alarms at central from TeleMon, use the following procedure.
Step 1.
Step 2.
Information
The following table lists all the information messages that TeleMon can display. These
Messages
messages are text only; no sound is generated at TeleMon when any of these conditions is
active.
Warning Warning
When local alarms are off, information messages at TeleMon are silent.
If multiple information messages are active, an up arrow (↑) will be displayed to the right of
the information message area. Messages will cycle through the sector at a rate of one every
two seconds. There is no audible indicator for any information signal.
All information messages are non-latching, that is, the information message resets
automatically when the condition is corrected, and the information message is erased from the
display. NBP information messages will remain on the display until the situation is corrected.
Visual Indicators on TeleMon for Information Message Conditions:
•
Message CENTRAL ALARMS SUSPENDED displayed in red on top banner
opposite the date.
Number of minutes remaining in the suspension period displayed above the Suspend
Alarms key.
The SUSPEND at Central key label changed to xx:xx min to UN SUSPEND.
When the transmitter is undocked, the suspend capability reverts to standard telemetry
Press the key below SUSPEND at Central to suspend all telemetry alarms at
central for 3 minutes.
To restart suspended alarms, press xx:xx min to UNSUSPEND.
Message displayed in information message area
Troubleshooting, Service and Repair
Troubleshooting
5-3