Install Lockbody Cassette; Latch Rod Guides - Assa Abloy Corbin Russwin FE6600 Series Installation Instructions Manual

FE6600 and BL6600 Series
Multi-Point Lock
Installation Instructions
5 Addendum (cont .)
c

Install Lockbody Cassette

• Using the supplied 3/32" Allen wrench, rotate both
Lockbody Cassette (LBC) worm gears to align
slots in the LBC gears to the orientation shown.
(Figure 36)
Alignment is needed for
proper installation of the
rod guide. (Step 3h)
• Slide the LBC into the door case and secure with
two (2) #12-24x1" flat head screws.
(Figure 37)
d

Latch Rod Guides

• Rod guides help installation by directing the rod
into location in the LBC within the door cavity.
• Pull rod guides away from latches on both
rods until they stop. (Figure 38)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Worm Gear
Slot
Figure 38
LBC Gear
Worm Gear
Figure 36
Figure 37
Note:
Bolt retainer clips
must remain attached
until step 5g.
18
Retainer Clip
FM440 03/20