Assa Abloy Corbin Russwin FE6600 Series Installation Instructions Manual page 11

FE6600 and BL6600 Series
Multi-Point Lock
Installation Instructions
3 Installation (cont .)
h Top and Bottom Latch Adjustment (cont .)
Using supplied 3/32" Allen wrench, rotate top
or bottom worm gears according to directions
below (Figure 19). Bolt to strike clearance should
equal 1/16". This sets bolt projection. (Figure 20)
Note:
Ten (10) turns equals approximately 1/16".
Rotate top
counterclockwise
project bolt;
clockwise
bolt.
Rotate bottom
counterclockwise
retract bolt;
clockwise
bolt.
Note:
Latches have bottomed
if worm gears click.
Tighten set screws. (Figure 21)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
to
to retract
to
to project
Figure 21
TOP OF DOOR
BOTTOM OF DOOR
Figure 19
Worm Gear
Worm Gear
Figure 20
IMPORTANT:
Set screws must be fully
tightened after adjustment.
11
1/16" Bolt to strike clearance.
1/16" Bolt to strike clearance.
FM440 03/20