Table of Contents
Advertisement
8800 Series Mortise Lock
Used with VN Escutcheon Trim and V Series Indicators
Installation Instructions
5
Installation
Prepare Door
1
Prepare door for function holes, size, and location
according to 7088-0005 door marker template, if not
already prepped.
Install Lock
2
1.
Verify strike location according to
template. Clean out door pocket and
door edge of debris.
2. Make sure handing of lock matches
handing of door. Slide lock into door.
(Figure 6)
3. Temporarily hand tighten two (2)
lock screws (#12 x 1-1/4" wood
screws, or #12-24 x1/2" machine
screws).
NOTE: Keep door open until installation is complete.
Install Outside Trim
3
1.
Verify lock is in unlocked state (square control
hub slot should be oriented as a diamond).
2. Unscrew the inside spindle from the outside lever
assembly 1/2 turn and align the ramp in the hori-
zontal position before inserting into the lock.
3. Slide outside escutcheon assembly on door and
insert outside lever assembly and plastic bushing
into lock body. Lever must be horizontal. (See
Figure 7)
NOTE: If indicator is used on outside, align indicator
®
For technical support contact Yale
at 800.438.1951 x5033 or support@yalelocks.com
Copyright ©2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part
without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
spindle with control hub.
Inside of door
Lock
Screws
Plastic Bushing
4
Outside
of door
RH door
shown
Lock
Outside Escutcheon
Assembly
Outside Lever
Assembly
80-8800-0017-000 12/20
Figure 6
Figure 7
Advertisement
Table of Contents
