Secure Top Latch; Tighten Set Screw - Assa Abloy Corbin Russwin FE6600 Series Installation Instructions Manual
Multi-point lock
Hide thumbs
Also See for Corbin Russwin FE6600 Series:
- Installation instructions manual (8 pages) ,
- Installation instructions (4 pages) ,
- Installation/wiring instructions (2 pages)
Table of Contents
Advertisement
FE6600 and BL6600 Series
Multi-Point Lock
Installation Instructions
5
Addendum (cont .)
i
Secure Top Latch
• Install four (4) 10-24 oval head
screws on the face of the door.
(Figure 44)
• Install six (6) 1/4-20 flat
head screws in the top edge of the
door. (Figure 45)
Note:
Do not fully tighten until all
screws are installed.
• Install two (2) screw retainers
(top latch only).
• Install two (2) #4-40 flat head
screws (top latch only).
j
Tighten Set Screw
Using the supplied 1/8" Allen wrench, tighten the set screw to secure the rod to the LBC. (Figure 46)
IMPORTANT:
Latches will not retract if the set screw is not tightened.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Figure 44
Figure 45
Figure 46
21
FM440 03/20
Advertisement
Table of Contents
Need help?
Do you have a question about the Corbin Russwin FE6600 Series and is the answer not in the manual?
Questions and answers