Top And Bottom Latch Adjustment - Assa Abloy Corbin Russwin FE6600 Series Installation Instructions Manual

FE6600 and BL6600 Series
Multi-Point Lock
Installation Instructions
3 Installation (cont .)
h

Top and Bottom Latch Adjustment

1. With door hung, measure clearance between
top and bottom bolts and strikes. (Figure 15)
Note:
If both measurements equal 1/16", proceed
to Step 3i, otherwise proceed with Step 3h as
follows:
2. Remove mortise filler cap and discard.
(Figure 16)
3. Retract latches by rotating lever and opening
door. (Figure 17)
4. Using supplied 1/8" Allen wrench, loosen set
screw 1/4 turn maximum. This allows hex
rods to rotate during latch bolt adjustment.
(Figure 18)
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2017, 2019, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in
whole or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Figure 17
TOP OF DOOR
BOTTOM OF DOOR
Figure 15
Figure 16
Note location
of set screws.
Figure 18
10
1/16" Bolt to strike clearance.
1/16" Bolt to strike clearance.
FM440 03/20