Equipment Specifications - Schulte FLX-1510 Operator's Manual

Flex-arm

Table of Contents

Your Schulte model FLX-1510 FLEX-ARM is designed to attach to a Schulte 10' or 15' cutter and be primarily used to cut

weeds, grass, and brush up to 2" in diameter. The FLEX-ARM allows the operator to travel on the road while the 10' or 15'

cutter cuts the ditch slope. With proper maintenance as described in this manual, your FLEX-ARM and Cutter will provide

you with years of dependable service.

Before beginning operation, it is necessary that all operators of this implement read this manual and understand the content

of the manual, especially the sections that pertain to safety, proper operation and maintenance.

Your FLEX-ARM and Cutter have been assembled for operation with a tractor PTO input speed of either 540 or 1000 RPM.

You will use the CV drive shaft from your rotary cutter to connect the FLEX-ARM to the tractor.

When ordering service parts, make sure to specify your serial number. Your serial number is located on the left end of the

main frame.

Driveline and gearbox shielding are essential safety components of your machine and must remain in place at all times.

To activate your warranty, the warranty validation form must be complete in full and returned to Schulte Industries Ltd.

within thirty (30) days of the date of purchase.

Transport Width

Transport Width with Cutter

Transport Length

Transport Length with Cutter

Approximate Weight

Swing Range

Hitch Load

Recommended Tractor HP

Ground Clearance

Minimum Tractor Hydraulics

Recommended Tractor Hydraulics

FLX-1510 06/18

INTRODUCTION