Universal Joint Assemblies; Frame - Schulte FLX-1510 Operator's Manual

Flex-arm
Table of Contents

Advertisement

Universal Joint Assemblies

-Type of Grease: A good quality NLGI #2 EP grease, lithium soap base should be used to grease the needle
bearings in cross journals, shield bearings, telescoping members and CV centering mechanism. For heavy
duty applications a compatible grease with 3 to 5% molybdenum disulfide additive may be used.
-Cross Journals: Every 8 hours.
Lubricate until grease purges from underneath all four needle bearing caps.
-Shield Retaining Bearings: Every 8 hours.
The shield bearings are greased by a fitting molded into the shielding bell. Three pumps are required.
Check that the driveline shielding is not damaged and rotates freely on the driveline.
-Constant Velocity Body: Every 4 hours.
The housing for the CV body serves as a reservoir for the lubrication of the centering mechanism.
Approximately 30 pumps are required every 4 hours.
-Telescoping Tubes: Every 4 hours. Apply grease to the collar located at the middle of the shaft. The grease
fitting on this collar will come exposed when the cutter wings are laying flat. Occasionally (monthly) pull the
universal joint halves apart and apply grease to all sides of the slip shaft. At least once per year (more often in
dusty or dirty conditions) the shielding should be removed and the old grease removed with a solvent. A fresh
coat of grease should then be applied to the entire surface of the inner tube.
If the universal joint sliding members are allowed to dry out to the point where two halves
cannot slip freely, damage to the rotary cutter or tractor may occur.
Always wear protective gloves when handling grease.

Frame

NLGI #2 EP molybdenum disulfide fortified grease is preferred for all sliding contact type applications such as
frame pins.
Frame pivot points: Daily during the first week of usage, and every 50 hours of operation thereafter, 16
locations:
(1) Hitch clevis, swivel
(1) Hitch frame, main pivot
(2) Arm link, both ends
(1) Arm, main pivot
(2) Castor frame link – 15' configuration only
(1) Castor frame, pivot – 15' configuration only
(1) Hydraulic cylinder – rod end
(2) Castor pivot sleeve
(2) Hitch tongue – cross pin grease fitting is on bottom side of sleeve
FLX-1510 06/18
© 2018 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-5

Advertisement

Table of Contents
loading

Table of Contents