ASSEMBLY
Selector Valve Switch Box
The selector valve switch circuit includes a 5 amp fuse. Attach the fuse side of the wire to battery positive.
Connect Lights
Hook up lights by taking the 7 pin tractor plug from
the cutter and attaching it to the receptacle located
under the lights on the right hand side of the FLEX-
ARM.
Install the Driveline between the Rotary Cutter and the FLEX-ARM
Use the driveline that was shipped with the FLEX-
ARM to connect the drive between the FLEX-ARM
and rotary cutter. Ensure that driveline yokes and
gearbox shafts are dirt free and greased before
attachment. The yokes on this drive shaft use a
tapered pin to lock the yoke to the gearbox input
shafts. Slide the yoke onto the rotary cutter's divider
gearbox shaft, align the tapered pin to the groove
on the gearbox shaft and tighten the nut on the
tapered pin.
IMPORTANT: The tapered pin must align with the
groove in the gearbox shaft in order to get a secure
connection.
Repeat for the yoke that will attach to the FLEX-
ARM gearbox shaft.
FLX-1510 06/18
Assembly Section 3-12
© 2018 Alamo Group Inc.