Table of Contents
Advertisement
STANDARD EQUIPMENT & SPECIFICATIONS
FM-115 FRONT MOUNT 3PT HITCH FRAME
Tractor Horsepower, Maximum
Tractor Horsepower, Minimum
Tractor Hydraulic Requirement
Tractor PTO
Lift Capacity, Maximum
Adjust-ability
Nominal Ground Clearance
Normal Lift Range
Approximate Weight
Note that front end weights are not necessary with this implement since the snow blower is carried on the front
end of the tractor. Rear wheel weights may be necessary to increase traction on smaller tractors.
FM-115 07/15
© 2015 Alamo Group Inc.
INTRODUCTION
115 HP (86 kW)
55 HP (41 kW) for SDX-840, 85 HP (63 kW) for SDX-102, RDX-102
3 remote circuits with a minimum total hydraulic output of 10 GPM
at 1200 PSI. An additional circuit is required if the snow blower has
a rotating drum.
540 RPM
5000 lbs (1162 KG)
Fits tractors between 111-1/2" and 164-1/2" measured the front
mount plate to the drawbar pin (Dimension 'A' on Page 3-2)
10" depending on tractor installation
18"
1400 lbs (636 KG)
Introduction Section 2-3
Advertisement
Table of Contents
