Standard Equipment & Specifications - Schulte FM-350 Operator's Manual

STANDARD EQUIPMENT & SPECIFICATIONS
FM-350 FRONT MOUNT 3PT HITCH FRAME
Tractor Horsepower, Maximum
Tractor Horsepower, Minimum
Tractor Hydraulic Requirement
Tractor PTO
Lift Capacity, Maximum
Adjustability
Nominal Ground Clearance
Normal Lift Range
Approximate Weight
Note that front end weights are not necessary with this implement since the snow blower is carried on the front
end of the tractor. Rear wheel weights may be necessary to increase traction on smaller tractors.
FM-350 10/14
© 2014 Alamo Group Inc.
INTRODUCTION
250 HP (186 kW)
85 HP (63 kW) for SDX-960 and RDX-960, 140 HP (104 kW) for
SDX-110, RDX-110 and SDX-117
3 remote circuits with a minimum total hydraulic output of 10 GPM
at 1200 PSI. An additional circuit is required if the snow blower has
a rotating drum.
1000 RPM for SDX110, RDX-110, SDX-117 and SDX960, 540 RPM
for SDX960 only
5000 lbs (1162 KG)
Fits tractors between 151" and 211" measured the front mount plate
to the drawbar pin
13" depending on tractor installation
18"
1720 lbs (1162 KG)
Introduction Section 2-3