MAINTENANCE
Nut and Bolts
1. Check all nuts and bolts for tightness after the first 8 hours of operation, then weekly. Check the condition
of cotter pins, roll pins and other fasteners weekly and replace if necessary.
2. Castor spring adjustment
A compression spring is used to maintain
friction between the castor swivel plates and
reduce the tendency of the castor wheel to
whip. Compression spring tension should be
set as follows:
•
Tighten the lower nut until the spring is fully
compressed.
•
Back the lower nut by one full turn.
•
Hold the position of the lower nut and tighten.
3. Bolt Grades and Torque
When replacing damaged bolts use only plated Grade 5 bolts unless otherwise specified. Use only bolts of
the correct length [Refer to the "Parts" section]. Do not replace lock nuts with nuts and lock washers. Use
only original equipment lock nuts.
Recommended Torques in foot pounds for SAE Grade 5 bolts, based on dry assembly:
FLX-1510 06/18
© 2018 Alamo Group Inc.
MAINTENANCE
Maintenance Section 5-6