Taylor-Dunn SC-090-24 Operation, T Roubleshooting And Replacement Parts Manual page 63

9. Punch or drill a small hole into the center of both of the intermediate
shaft bore plugs.
10. Thread a sheet metal screw into each plug until the bore plug is
forced out.
11. Remove both snap rings from the intermediate shaft bore.
12. Using a soft metal or hard wood dowel, drive the intermediate
shaft through the bearing just enough to allow clearance for an
ID bearing puller. Do not attempt to drive the shaft out of the
opposite end of the transmission.
13. Remove the intermediate bearing with an ID bearing puller.
The shaft and gear assembly must be supported
by hand during the next step. Failure to properly
support the shaft and gear assembly could
result in damage to the gear teeth.
14. While supporting the shaft and gear assembly, repeat steps
#12 and #13 for the opposite side bearing and remove the
intermediate shaft from the housing.
Maintenance, Service, and Repair
Transmission
Page 5