Moist Charge Batteries - Taylor-Dunn SC-090-24 Operation, T Roubleshooting And Replacement Parts Manual

15. Install the batteries in reverse order. Refer to the
Illustrated Parts List for battery cable routing.
16. It is recommended to replace the battery terminal
hardware when replacing the batteries.
When torquing battery hardware, use a
backup wrench on the battery bolt and
tighten the nut. Failure to use a backup
wrench may damage the battery post.
17. Torque the terminal hardware to 7-8 ft.-lbs.
18. Tighten the hold downs so that the batteries are
secure but not so tight as to deform the batteries.
19. Remove the blocks from the wheels and test drive.

Moist Charge Batteries

Moist charged batteries are shipped without battery
electrolyte. This allows for a much greater shelf life of
the battery. Moist charged batteries must be filled with
electrolyte and charged before putting into service.
Battery electrolyte is a solution of acid and water that
is formulated to be used in wet lead acid batteries and
is available at most automotive parts distributors that
carry batteries.
Do not operate or charge a vehicle equipped
with moist charged batteries until the
batteries have been filled with electrolyte
and charged. Operating or charging moist
charged batteries before filling and charging
will damage the batteries resulting in
premature failure of the batteries.
Battery electrolyte will stain and corrode
most surfaces. Immediately and thoroughly
clean any surface outside of the battery
that the battery electrolyte comes in
contact with. Failure to clean may result in
property damage.
Maintenance, Service, and Repair
Battery electrolyte is poisonous and
dangerous. It contains sulfuric acid. Avoid
contact with skin eyes or clothing. Wear
rubber gloves and safety glasses while
servicing batteries. DO NOT INGEST! This
may result in severe bodily injury.
A battery is a live electrical source. It
cannot be disconnected or neutralized. Do
not drop any tool or conductive object onto
the battery. A conductive object that comes
in contact with the battery terminals will
initiate a short circuit of the battery. This
could cause the battery to explode resulting
in severe bodily injury and/or property
damage.
1. Make sure the key-switch is in the "OFF"
position, then remove the key.
2. Place the forward-reverse switch in the
center "OFF" position.
3. Set the park brake.
4. Place blocks under the front wheels to
prevent vehicle movement.
5. Disconnect the main positive and
negative cables at the batteries.
6. Fill all battery cells with electrolyte to the proper
level.
7. Thoroughly clean any spilled electrolyte from
the batteries or the ground. Refer to
the Batteries
batteries.
8. Reconnect the battery cables, connect the
batteries to the charger and allow the charger to
complete one charging cycle.
9. Remove the blocks from the wheels and test drive.
The batteries are now ready to be put into service.
Cleaning
for information on cleaning the
Batteries
Page 7