Taylor-Dunn SC-090-24 Operation, T Roubleshooting And Replacement Parts Manual page 86

Battery Charger
REMOVE/INSTALL
HIGH VOLTAGE
Disconnect the batteries and make sure that the AC
power cord has been unplugged before disconnecting
any wires or removing the cover of the charger.
Failure to follow this instruction may result in serious
injury due to electric shock and/or property damage.
There are many charger options available for this model. The
different charger may have different wiring connections.
Disconnect the batteries and make sure that the AC power
cord has been unplugged before disconnecting any charger
wires or cords.
Some charger models have disconnects close to the charger
and some have full length wire and molded cords. When
replacing chargers with full length wires and molded cords,
DO NOT cut and splice the wires or cord. Cutting the wires or
cord will void the charger warranty and may result in incorrect
operation of the charger or premature failure.
Page 2
TROUBLESHOOTING
Troubleshooting control system is not included in this manual.
All electrical troubleshooting information is included in a
separate manual "Troubleshooting Electric Vehicles".
The manual part number is M7-001-69 and was provided
on the original vehicle CD. A hard copy can be purchased
from your authorized Taylor-Dunn distributor or can be
downloaded from the Taylor-Dunn web site.