Taylor-Dunn SC-090-24 Operation, T Roubleshooting And Replacement Parts Manual page 123

75-442-55: Pin Removing Tool
Removes pins from Molex Mini-Fit harness
connectors.
77-200-00: Hydrometer
Used for testing battery electrolyte.
Illustration is of a typical hydrometer, actual
hydrometer type may vary.
75-089-00: Throttle Module Test Harness
Used in conjunction with a volt meter to test
the throttle module. The module must be
installed in a working control system.
Note: Part # 62-027-31 includes instructions
41-350-13: Disc Brake Boot Installation Tool
Assists in installing the rubber boot onto the
disc brake piston.
72-201-00: Battery Filler
Used to safely add water to batteries.
Equipped with splash guard and auto-
shutoff when cell is full.
Appendixes
70-440-55: Pin Removing Tool
Removes pin from Amp circular harness
connectors.
96-500-48: GT Drive Oil Fill Plug Tool
Used to remove the oil fill plug on GT drives.
It is used with a 3/8" drive extension (not
included).
Appendixes
Appendix A
Page 3