Accessory Switch (Optional); Battery Status Indicator, Analog; Battery Status Indicator, Digital Bargraph; Steering - Taylor-Dunn SC-090-24 Operation, T Roubleshooting And Replacement Parts Manual

SAFETY RULES AND OPERATING INSTRUCTIONS

Accessory Switch (Optional)

The accessory switch is located on the left side of the instrument panel and
to the right of the headlight switch. Push the top of the switch to turn on the
accessory. Push the bottom of switch to turn off the accessory. The accessory
can be turned on with the key switch in the "OFF" position. If a vehicle is
equipped with windshield wipers and one or more accessories, the windshield
wipers are controlled from this switch. Other accessories are controlled from
the auxiliary switch.

Battery Status Indicator, Analog

The battery status indicator is located to the left of the hour meter. The normal
operating range is in the green zone. Park the vehicle for a few minutes for
an accurate reading. The vehicle needs charging if it is in the yellow zone.
During and immediately following charging, the needle will be in the red zone
to the right. The needle will move through the green zone toward the yellow
zone as the batteries discharge. Charge the batteries when the needle is
in the yellow zone. If it is in the red zone to the left, the batteries are empty
and the truck should be taken out of service and charged to avoid damaging
the batteries. Refer to following pages for information on the optional Smart
View gauge.

Battery Status Indicator, Digital Bargraph

The battery status indicator is located to the left of the hour meter. The battery
status indicator has a LED bar graph that indicates the relative state of charge
of the battery. The top LED will light only when connected to a fully charged
battery or after completing a charging cycle. Successive lower LED's will
light as the battery charge diminishes. When the second from the bottom
LED flashes the battery energy status is in energy reserve and should be
placed on charge as soon as possible. When the two bottom LED's are
alternately flashing the batteries are empty and the truck should be taken out
of service and charged to avoid damaging the batteries. The BSI will reset
to fully charged only after a complete charge cycle is completed. A complete
charge cycle is defined as battery voltage exceeding 2.35 volts per cell for a
minimum of 6 minutes.

Steering

The steering wheel and steering system are similar to an automobile. To turn
right, turn the steering wheel clockwise. To turn left, turn the steering wheel
counter-clockwise.

Accelerator Pedal

The accelerator pedal is the treadle located on the right side of the floorboard
positioned under the operators right foot. The treadle also functions as the
brake pedal. Press the front of the treadle down to increase speed, release
the treadle to slow down.
Safety Rules
Page 5